# How much is pool water delivery

## How much does it cost to fill a 10000 gallon pool?

Determine CostGallons Of WaterCost To Fill With Water5,000\$4510,000\$9015,000\$13520,000\$180

## How much does it cost to fill a 30000 gallon pool?

The average cost to fill in a pool with water is \$80 to \$160 for adding 15,000 to 30,000 gallons to your water bill. Bulk pool water delivery by truck costs \$500 to \$1,500 or \$0.042 to \$0.074 per gallon based on the amount needed and if it is already chlorinated.

## Is it cheaper to fill a pool with a hose?

The average homeowner uses about 12,000 gallons of water per month. The average pool is somewhere between 15,000- 30,000 gallons. Using that simple math, it stands to reason that your water bill will at least double when you fill your pool for the first time from a hose.

## Will the fire department fill your pool?

USING WATER FROM THE FIRE DEPARTMENT

It used to be common enough for fire departments to fill swimming pools, but these days you’re quite lucky if you’re able to pull off a request. This could be less expensive than some of the alternatives as some departments will fill your pool or hot tub in exchange for a donation.

## How often should you have to add water to a pool?

Normally pools see ¼ – ½ inch loss of water per day due to evaporation. This is roughly 2 – 4 inches per week. For a normal sized pool you will loose 25,000 to 50,000 gallons of water per year due to evaporation. This means I was putting a hose in the pool every 7-10 days to fill the pool.

You might be interested:  How to clean pool tile with vinegar

## Can you fill a pool overnight?

Hi, with 12″ of water in the pool you should be fine to let it fill all night. The stretching should be done and the liner tight against the wall. If so, let it go. There is some air gap between the liner and the wall in a few areas.

## Can I just fill my pool with dirt?

Option 1: Filling in a pool (partial removal)

Filling in a pool involves draining the pool, punching holes in the bottom, demolishing the top layer of the pool (18″ – 36″), placing the rubble in the bottom, filling in the pool with additional dirt and topsoil, and compacting the soil.

## Is it OK to fill a pool with well water?

Filling a Pool with Well Water: What to Consider. … If it has a high flow rate, the well can most likely fill a pool, but with a low flow rate, it may run dry. You should also consider whether you’re sharing the water table with neighbors and whether you’re currently in a drought.

## What do you do with a pool you don’t want?

Here are three ideas for that unused pool:

1. Remove it. The cost will depend on the size of your pool, and also on whether an earthmover can easily get into your yard. …
2. Retire it. …
3. Cover it temporarily.

## How soon after filling a pool Can you swim?

Do not swim in the pool until after the start-up procedure has been completed. Do not use any automatic pool cleaners for a minimum of three weeks after plastering.

You might be interested:  How to remove rust stains from pool

## How do I treat my pool for the first time?

Filling your new pool for the first time?

1. Place the garden hose in the deep end of the pool, making sure to tie a cloth over the end of the hose to diffuse the water pressure. …
2. Test and correct the pH level to 7.2 – 7.6.
3. In the early evening, add 2 cups of HTH® Granular for every 10 000 liters of pool water. …
4. Filter continuously for 24 hours.

## Should I fill my pool with soft water?

Soft Water Must be—Harder!

The trouble in filling a swimming pool with softened water is that “soft water” may seek to balance itself by leeching calcium directly from pool walls—causing the pool’s plaster or tile grout to dissolve, corrode and eventually crumble. … Basically, all that wonderful soft water is now harder.

## How long does it take to fill a 4000 gallon pool?

Fill It Up

At 540 gallons per hour, it will take about nine hours to fill a 5,000-gallon pool with your 1/2-inch hose. If you have a larger hose, the time to fill your pool will be reduced.