How to fill a swimming pool

How do I fill my inground pool with water?

How to Fill an In-Ground Pool With Water

  1. Your Water.
  2. Call the water company and tell them you are going to fill your swimming pool. …
  3. Run the hose to the pool with enough slack that the end of the hose is on the bottom of the pool.
  4. Turn on the hose and allow the water to run until the water level is about 6 inches from the top edge of the pool.

What chemicals do you put in a pool for the first time?

How To Maintain A Swimming Pool Part 1 (Chemicals)

  • Chlorine- This is your primary sanitizer. …
  • Bromine- Bromine is an alternative to chlorine. …
  • pH- This is a measure of the water’s total acid-alkalinity balance. …
  • Shock- This is another type of chlorine. …
  • Alkalinity- Also referred to as total alkalinity is a measure of alkaline in the water.

What chemicals do I add to fill my pool?

Startup Chemicals to Open Your Pool

  • Optional Anti-scaling Product. If you’re filling your pool with fresh water, this is a good time to add an anti-stain or anti-scaling product. …
  • Adjust the pH. …
  • Adjust Total Alkalinity. …
  • Sanitize the Water. …
  • Adjust Hardness. …
  • Add Algaecide.

Do fire departments fill swimming pools?

USING WATER FROM THE FIRE DEPARTMENT

It used to be common enough for fire departments to fill swimming pools, but these days you’re quite lucky if you’re able to pull off a request. This could be less expensive than some of the alternatives as some departments will fill your pool or hot tub in exchange for a donation.

You might be interested:  How to disassemble a slate pool table

Can I fill my pool at night?

Hi, with 12″ of water in the pool you should be fine to let it fill all night. The stretching should be done and the liner tight against the wall. If so, let it go. There is some air gap between the liner and the wall in a few areas.

How long after filling a pool Can you swim?

After the pool is full it usually takes up to 1 week before the pool is ready for you to swim. The shortest timeline we have seen for swimming after filling a plaster pool is 5 days.

How often should I add water to my pool?

For a normal sized pool you will loose 25,000 to 50,000 gallons of water per year due to evaporation. This means I was putting a hose in the pool every 7-10 days to fill the pool.

How much does it cost to fill a 10000 gallon pool?

Determine CostGallons Of WaterCost To Fill With Water5,000$4510,000$9015,000$13520,000$180

How do you start a pool for beginners?

How to Open a Pool

  1. Step 1: Clean up debris and check for wear and tear. …
  2. Step 2: Inventory your pool chemicals. …
  3. Step 3: Remove the Cover. …
  4. Step 4: Inspect the Pool. …
  5. Step 5: Fill the Pool Water Midway and Do a Final Debris Removal. …
  6. Step 6: Turn on the Pool Filter and Test the Water.

How do I add chlorine to my pool for the first time?

Filling your new pool for the first time?

  1. Place the garden hose in the deep end of the pool, making sure to tie a cloth over the end of the hose to diffuse the water pressure. …
  2. Test and correct the pH level to 7.2 – 7.6.
  3. In the early evening, add 2 cups of HTH® Granular for every 10 000 liters of pool water. …
  4. Filter continuously for 24 hours.
You might be interested:  How to shoot a pool stick

How much baking soda do I add to my pool?

A rule of thumb is 1.5 lbs. of baking soda per 10,000 gallons of water will raise alkalinity by about 10 ppm. If your pool’s pH tested below 7.2, add 3-4 pounds of baking soda. If you’re new to adding pool chemicals, start by adding only one-half or three-fourths of the recommended amount.

How much chlorine do I put in a 5000 gallon pool?

6 ounces initially per 5,000 gallons and a a maintenance dose of . 75 ounces per 3,000 gallons every week. Initially you will need stabilizer to protect the chlorine from the sun. This is added at a rate of one pound per 3,000 gallons of water.

What to do after filling a pool?

Test your water immediately after refilling to balance and add start-up chemicals. You can also take a water sample into a Leslie’s store for testing. Leslie’s will test your water and provide the results with a prescription for improving your water quality.

Leave a Reply

Your email address will not be published. Required fields are marked *