How to operate pool pump valves

How should pool pump valves be set?

How to Set Pool Valves. A normal pool valve setting would have the skimmer valve(s) fully open, main drain half-open and spa drain fully closed. To operate a suction pool cleaner or manually vacuum the pool, you can close other skimmers, or close the main drain, to obtain more suction through the skimmer you are using.

What setting do you put your pool filter on when vacuuming?

For routine vacuuming, the filter valve is left in the normal “Filter” position. This directs dirty vacuum water through the pool filter to remove the contaminants, then conveys filtered water through return lines back to the pool. The “Filter” setting is used for light to moderate levels of pool sediment.

Where should a pool check valve be installed?

As such, a common location for a check valve is on the incoming suction pipe, in front of the filter pump. For best results with pump priming, especially for pumps lifting more than 24” from the water surface, the check valve should not be installed directly against the pump intake, but 12”-18” in front of the pump.

How do I know if my Jandy valve is open?

Jandy 2-Way Valves

On a two port Jandy valve, the valve has two closed positions and one open position. On the left, the valve is closed because the diverter is blocking the flow of water through the port. In the center, the diverter is blocking nothing, so the valve is open and water can flow through it.

Should skimmer valve be open or closed?

For the cleaner to operate at maximum efficiency, only the skimmer and cleaner valves should be open. No other valves should be open. Valves are positioned for a suction cleaner. Main drain fully closed, skimmer open half way, cleaner line fully opened.17 мая 2019 г.

You might be interested:  How much is a pool filter

Can you die from pool drain?

The vacuum effect in pool drains is powerful enough to hold swimmers, especially children, to the bottom of a pool. … Swimmers can die from drowning or evisceration. From 1999 to 2008, according to CPSC data, there were 83 reports of suction entrapment, including 11 deaths and 69 injuries.

How does a pool filter valve work?

Water is pulled from the pool by your pool pump and pushed into the “PUMP” port of the multiport valve where it enters the filter tank. … After passing through the filter media, the water exits the tank again into the multiport valve, leaving through the “RETURN” port, and back to your pool.

Can you vacuum a pool on backwash?

You can vacuum a pool on backwash, in theory at least, but it would have no benefit. The water would be pumped backwards through the filter, trapping much of the dirt, before passing out through the backwash hose. This dirt would then end up back in the pool once the pump was back on the filter setting.

How often should you backwash a pool filter?

As a general rule, you should be backwashing your pool about once a week or in conjugation with your scheduled maintenance. Another industry standard is to backwash when your filter’s pressure gauge reads 8-10 PSI (pounds per square inch) over the starting level or “clean” pressure.

Leave a Reply

Your email address will not be published. Required fields are marked *