What size cartridge filter for 20000 gallon pool

What size cartridge filter do I need for my pool?

Cartridge Filters

I have a rule of thumb for cartridge pool filters: 100 sq. ft. of filter surface area per 10,000 gallons of pool water, as a minimum.

What size filter do I need for a 15000 gallon pool?

So, let’s say you have a 15,000 gallon inground pool. With two turnovers per day, your minimum flow rate comes to 20.8 GPM. Let’s also say that you have a 2.3 square foot sand filter (50 GPM max) and 1.5″ plumbing (43 GPM).

What size sand filter do I need for a 20000 gallon pool?

Another rule of thumb is to buy 1.5 sq ft of filter area per 10,000 gallons of pool water. The 3.1 sq ft sand filter (24” tank) is the standard size for most inground pools. Larger pools, (over 30,000), should use a 4.9 sq ft. sand filter (30” tank).

What size pump and filter do I need for my pool?

Determine how many gallons you need to pump per hour to clean all the water in your pool in eight hours. Divide the gallons of water your pool holds (answer from step 1) by eight. Using the example number of gallons previously given, this equation would look as follows: 24,000 gallons ÷ 8 hours = 3,000.

Which is better sand filter or cartridge filter for pools?

Although they both have some advantages, a cartridge filter would be your best choice for your pool’s filtration system. A sand filter will only filter down to 20 microns while a cartridge filter will filter down to 10 microns, half the amount. … The maintenance of a cartridge filter is much easier than a sand filter.

You might be interested:  What size pool table do pros play on

Can a pool pump be too big?

Too large of a pump can cause poor filter performance and even damage it, if the filter is not also oversized accordingly. Another possible consequence is pump cavitation in which bubbles form in the water inside the pump and then burst with great force, resulting in damage to the impeller and other internal parts.

Can you over filter a pool?

Backwashing Your Pool Filter Too Often

Pool water washes funk and gunk out of your filter media, then exits through your filters backwash valve drain port. Backwashing is an important part of basic pool care, but overdoing it is one of the more common pool maintenance mistakes.

Is it OK to run pool pump without filter cartridge?

You can run your pool pump without a filter cartridge. You can do this to maintain the circulation when the cartridge is dried up. However, you will have to ensure that you have removed the internal parts and the tank is properly reassembled. Also, you can remove the cartridge while cleaning the filter.

Is it better to run a pool pump at night or day?

It may be cheaper to run the pump at night, but honestly you should run it 1 hour a day per 10 degrees of temperature at least, and it should be during the day. Running the pump at night should only be when you are doing a major chemical treatment such as algae clean-up.

How often should you backwash a sand filter?

As a general rule, you should be backwashing your pool about once a week or in conjugation with your scheduled maintenance. Another industry standard is to backwash when your filter’s pressure gauge reads 8-10 PSI (pounds per square inch) over the starting level or “clean” pressure.

You might be interested:  What is a saltwater pool

Will a sand filter catch algae?

As is generally understood, typical sand filters can remove and hold particles as small as about 20 microns. … Some people recommend adding D.E. to a sand filter as a way to catch very fine particles, such as dead algae.

Can I replace a 1hp pool pump with a 1.5 HP?

However, you can replace your 1.0 Full rated motor with a 1.5 HP uprated motor. This is because they both will have the same total horsepower. Don’t fret if your motor is not labeled uprated or full rated. In many cases, it may not be labeled at all.

Is it OK to run pool pump 24 hours a day?

Ideally, you should run your pump for 24 hours a day, but we know that’s unrealistic (and pricey), so let’s look for an answer that keeps your pool clean and your wallet full. Generally running your pool pump for 12-hours a day is a good option. … For a residential pool the water should turn over at least once per day.

How many hours a day should you run a pool pump?

12 hours

Leave a Reply

Your email address will not be published. Required fields are marked *