Swimming pool light transformer

What does a pool light transformer do?

A transformer reduces voltage, from a higher voltage to a lower voltage. Pool light transformers reduce the voltage from 120V down to 12 volts, to power low voltage, 12V pool lights. If you have this already, because your area requires 12V pool lights, then you’re all set!

How long do pool light transformers last?

All the marketing hype would have you believe that your new LED light will last for 50,000 to 100,000 hours (up to 12 years). This is a half truth really. Yes the LEDs themselves will normally last that long.

Can a 12v pool light electrocute you?

Because these lights operate at a very low voltage, they are less inherently dangerous when taken on their own. Some believe the 120 volts generated by an incandescent light can introduce a fatal charge, whereas the power from low-voltage lights, generally 12 volts, can injure but not kill.

Can a pool light electrocute you?

Faulty bonding/grounding is the cause of many pool electrocution incidents. Pool lights don’t have to be on to be a potential hazard. … This can send electricity through a pool light even if it’s not on during the daytime. Anything that has electricity running to it AND is underwater is a potential hazard.

Can you replace pool light without draining pool?

Typically, backyard swimming pools are equipped with 1 or more underwater lights. … There is no need to lower the water level in your pool to replace the burned-out bulb. Instead, you can remove the light housing from the side of the pool, pull the fixture up onto the side of the pool, and change the light bulb there.

You might be interested:  Swimming pool fiberglass cost

Why is my LED pool light not working?

Check the circuit breaker panel that’s usually found on the side of your house. If the breaker that your pool light is on has been tripped, unplug whatever you just turned on or plugged in and then reset the breaker by turning it all the way off and then back on again. If that doesn’t work, you may have a bad breaker.

How do you ground a swimming pool light?

The junction box should be 18″ above the water level, to keep pool water out. Both ground wires from the light and breaker are connected together and pig-tailed to a green ground screw inside the J-box. An electrician should ground the light niche, to protect against any stray voltage.

How much does it cost to replace a pool light?

Fiber optic pool lights are usually around $1,300 to $1,700 installed. Full size incandescent pool lights are typically in the range of $450 to $650.

Are pool lights worth it?

An LED light will save you roughly 75% on your energy usage compared to a comparable incandescent light. REMEMBER, that LED pool lights cost more, on average, than a simple incandescent light so your cost savings will not start till you recoup the additional money that you spent on the LED lights.

Where is the pool light switch located?

Usually they are found directly behind the light, off the pool deck, or in some areas, the light J-Boxes are installed by the pool equipment pad.

Can you splice a pool light?

WRITTEN BY: Inyo Pools

You might be interested:  Swimming pool safety net

You could buy a whole new light fixture with a longer cord or you could splice into the existing cord and add to it. If you add a spliced cord, you should not put the splice underground inside the light wire’s conduit. That pipe generally collects water and the spice would eventually short out.

What is a Nicheless pool light?

A nicheless led pool light is very energy efficient. Usually, the lights draw only 9 – 30w at 120 volts alternating current. Just like many other low-voltage lightings, this light uses a transformer for power that is 120 VAC to 12- 14 VAC.

Leave a Reply

Your email address will not be published. Required fields are marked *