Why is my pool water level going down?
No matter which season you are in, your pool can lose inches of water a week. Natural causes such as wind, heat and humidity can contribute to pool water loss. This is a big deal, because if your water level gets too low it may cause your pool pump to suck air and run dry, which can damage it.
How often do you need to add water to a pool?
Normally pools see ¼ – ½ inch loss of water per day due to evaporation. This is roughly 2 – 4 inches per week. For a normal sized pool you will loose 25,000 to 50,000 gallons of water per year due to evaporation. This means I was putting a hose in the pool every 7-10 days to fill the pool.
Do I need to lower the water level in my pool?
Water Level: The water level in your pool should be kept at or just below the skimmer when the cover is in use. The water level should not be lower than 18″ from the top of the pool. … Check pool water level periodically over the winter, adding or removing water when necessary with your garden hose or cover pump.
How do you calculate water loss in a pool?
Pool Water Loss Formula
Multiply the length (L) times width (W) times the amount of the water loss (WL) in inches times . 6233 for a rectangular pool. Example: L-32′ x W-18′ x WL 2″ x . 6233 = 718.04 gallons in 24 hours.
Should I add water to my pool?
Everything from evaporation and heavy rains to running your pool pump can affect your pool’s water level. … You should also keep in mind that routine maintenance activities like vacuuming and backwashing your pool can also lower your water levels, so be sure to add water as needed.
What to do after adding water to pool?
Pool Startup Chemicals Guide
- Optional Anti-scaling Product. If you’re filling your pool with fresh water, this is a good time to add an anti-stain or anti-scaling product. …
- Adjust the pH. The first step when treating your pool’s water is to adjust the pH. …
- Adjust Total Alkalinity. …
- Sanitize the Water. …
- Adjust Hardness. …
- Add Algaecide.
How do I keep my pool from evaporating?
This article is on saving water, but it focuses only on tactics to slow evaporation.
- Cover your pool. First and foremost: Use a pool cover! …
- Try a liquid solar blanket. Don’t like the idea of using a solid cover or solar blanket on your pool? …
- Turn off any water features. …
- Reduce water temperature. …
- Add windbreaks.
Can pool water level be too high?
If the water level is too high the debris floating next to the opening may pass by without being pulled into the skimmer. However if the water level is too low it may cause the skimmer to suck air into the system. If this happens you may run the risk of burning up your pool pumps motor.
Where should the water level be in a pool?
Ideal Water Height
Most pool professionals agree that the water level in both in-ground and above-ground pools should be at the midpoint of the pool skimmer. The skimmer is responsible for providing a pathway for water to flow to the filter where it is cleaned.
What happens if pool has too much water?
If you get more than five inches of rain in an hour, or if your pool wasn’t properly designed with sufficient overflows, then your pool may overflow, which can put you at risk of water getting inside of your home and causing serious damage. As your pool fills with water, it may overflow into your yard.